CLI-MATE® devices are exclusively intended for the control of fans or extraction systems (such as professional kitchens), or as a component in an air treatment system.

All electronic chips required for operation are industrially configured and integrated in an IP44 protection casing. It also has a plate on the back that facilitates assembly and installation. appliance cooling.

In your case, the Cli-mate Twin Controller (8Amp) allows two settings for the minimum operating speed of the extractors (IN & OUT), in order to maintain the set internal temperature and negative pressure.

Installation

• Try to always install the controller outside the area under control, so that it is in an environment that favor its cooling.
• The CLI-MATE® controller must be connected following valid guidelines set by the electrical society, and to an outlet that supplies sufficient electrical current.
• Avoid placing the controller in a location highly exposed to intense heat and humidity levels.
• Try, above all, not to place it next to a source of heat (stoves, spotlights), or humidity (humidifier).

Features

• Inlet and outlet air control with independent settings.
• Fully adjustable, automatic temperature control.
• Easy to calibrate with the buttons.
• Voltage 220/230V
• Amperage 8 (4+4) A
• Includes rear mounting plate.
• Incorporates temperature sensor.
• Temperature range: 5-55ºC
• Differential: 1ºC at each step
• Protection type: IP44
• Dimensions: 140x220x110 mm

Note: NEVER exceed the maximum allowable load (AC motors)