In the end, every mode of cultivation will develop fertilizer residues as a natural part of the process. The agglomeration of these residues produces an accumulation of salts that can clog the drippers, cause unsightly accumulations on the ground or substrate.

Ultimately, your plants will have to exert unnecessary effort and even the roots could be harmed.

With the highly concentrated nutrients that are available on the market today and the high levels of electrical conductivity that run on In many systems, nutrient lockout can also present itself in the form of an invisible limit on their nutrients. crops; FlashClean® solves all these problems and more:

• Dissolves accumulated fertilizer salts
• Corrects nutrient balance
• Treats nutrient lockout
• Encourages microbial life and refreshes the soil and coir
• Maximizes growth during the final stage (especially with FinalPart®)
• Specifically developed to dissolve mineral salts, FlashClean® releases nutrient bonds between the minerals and the substrate and allows the excess residue to be clarified. This process also helps plants to get the most out of the remaining fertilizers, especially in the last week before harvest, which is crucial.

Unlike other wash and cycle purpose products available on the market, FlashClean® is not a acidic, does not have an enzyme base, and does not introduce magnesium or other mineral additives into your system, making from it an exceptionally flexible product: with FlashClean® you can give your system and your plants a new start at any time and stage of the growth process.

Regardless of the type of growing system you are using - indoor or outdoor, hydroponic, potted or in backyard gardens - FlashClean® is easy to use: simply mix it with pH-adjusted water and apply it.

How to use:

In recirculating hydroponic systems:

To readjust and refresh before changing nutrients (including before FinalPart®): add 1.5 to 3 ml/L of FlashClean® to the nutrient solution you are using and let it circulate for 24 hours before draining and replacing with a fresh new nutrient solution. Use the lowest dosage for the youngest or most fragile plants and the highest high for consolidated plants or close to harvest. After burning or nutrient lockout: Drain the old nutrient solution and add 1.5 to 3 ml/L of FlashClean® to pH-adjusted water (it is not necessary to use a full tank, but what is necessary so that circulate freely and that the system can work). Let circulate 24 hours before draining and adding a new fresh nutrient solution. Use the lowest dosage for the youngest or most fragile plants and the highest for consolidated plants.

As a final irrigation (after FinalPart®): Drain the old nutrient solution and add 1.5 to 3 ml/L of FlashClean® to pH-adjusted water (it is not necessary to use a full tank, but what is necessary so that circulate freely and that the system can work). Circulate it during the last two days before the harvest to increase sugar levels in your crop, avoiding losing aroma and medicinal content with a large discharge of water. In pots with soil and in mixtures without soil, including coconut fiber:

To renew and refresh before changing nutrients (including before FinalPart®) and after burning or nutrient blockage: every 15 days (or as needed after blockage, etc.), fill a watering can with fresh pH adjusted water and add 1.5 to 3 ml/L of FlashClean®. Soak until the water runs off the pot bottom. Go back to your regular fertilization schedule at the next watering. use dosage lowest for the youngest or most fragile plants and the highest for established plants. As a final irrigation / after FinalPart®: use 3 ml/L of FlashClean® instead of nutrients during the last two days before the harvest to increase the level of sugars in its crop avoiding losing aroma and content medicine with a large discharge of water. Note: FlashClean® can be used at any stage of growth or flowering, but do not use FlashClean® more than once. once every two weeks.