Newlite
Newlite 400W Dimmable Electronic Ballast with Potentiometer
BALA0019
For the correct operation of this equipment, a 3x1.5mm Male IEC Plug Cable is necessary, do not forget it.
400W electronic ballast with improved components for HPS High Pressure Sodium lamps, it is used as a component in lighting systems for greenhouses and small and medium-sized indoor growing areas, where the lamp and the reflector are installed separately. C13 ballast output connector, to connect with a standard C14 cable to a reflector.
Protection against lamp worn by use, short circuit, open circuit (lamp not installed), starter failure (lamp in bad condition) and thermal protection. It allows 15 meters of distance between the equipment and the lamp, with the appropriate wiring.
Welcome to the new era of progress. Thanks to high technology. now we can enjoy the NEWLITE Electronic Ballast.
With the NEWLITE Digital Electronic Ballast. Everything is Advantages.
* The Digital Electronic Ballast is characterized by its great efficiency and energy saving.
* Instant ignition and re-ignition.
* Flicker-free tubes when about to run out.
* Decreases visual fatigue.
* Does not cause stroboscopic effect.
* Higher performance.
* It is lighter. facilitating its installation.
* Decrease in losses. increasing the efficiency of the tube.
* Allows energy savings of up to 30%.
* Its temperature is lower.
* Silent.
Advantages of the NEWLITE Electronic Ballast over electromagnetic ones:
- Reduced weight.
- Special dimensions. can be adapted to the design of the luminaires.
- Elimination of flickering on the lamp electrodes.
- High power factor (around 0.99).
- Simplification of the installation (it has a single device).
- Possibility of varying the luminous flux of the lamp (adjustable ballasts).
- Power regulator: 50% -75% -100%.
- Compatible with Metal Halide (not CMH) and High Pressure Sodium lamps.
- Short circuit and protected in case of electric current fluctuation.
Specs:
- Voltage range: 220/240 V.
- Power source frequency: 47-63 Hz.
- Total harmonic distortion (THD): less than 10%.
